100+ staff · 1,500+ m² in Shenzhen and Hong Kong · Since 2002
ProductsIntegrated CircuitsTSC2007
PACKAGE REFERENCETSSOP-16 / WCSP-12Confirm case, pinout and ordering suffix before purchase.
MANUFACTURER PART RECORD

TSC2007

Texas Instruments

TSC2007 is a Texas Instruments nanopower 4-wire resistive touch screen controller in a 16-pin TSSOP or 12-pin WCSP package, depending on the ordering code — for battery-powered handhelds where every microamp matters: portable instruments, point-of-sale terminals and GPS units. 8- or 12-bit programmable resolution, an I2C interface, on-chip temperature and touch-pressure measurement, and preprocessing that filters touch data before it hits the bus. The nanopower operation is the selection point: its very low operating current means the touch subsystem barely registers on the battery budget, and the preprocessing offloads the host MCU from raw-sample filtering. Selection advice: the I2C interface suits pin-constrained designs — for SPI hosts the TSC2046 on this site is the alternative; the TSSOP-16 is the hand-solderable package, with a smaller WCSP-12 for dense layouts. Parameters verified against Texas Instruments documentation.

Integrated CircuitsI2C touch screen controllerTSSOP-16 / WCSP-12
MPN
TSC2007
Manufacturer
Texas Instruments
Family
I2C touch screen controller
Package
TSSOP-16 / WCSP-12
Manufacturer channel coverage
Checked by RFQ
Data last checked
Commercial check required
Required order checks
Suffix, package, date code, lot, source and traceability
PROCUREMENT DATA

Identity and sourcing requirements.

MANUFACTURER DATA REVIEW

Key technical specifications

Ordering-code highlights reviewed against official manufacturer documentation.

Function
4-wire resistive touch screen controller with 12-bit ADC · I²C interface
ADC resolution
12 bits maximum · programmable 8-bit or 12-bit mode; no missing codes 11 bits minimum at 12-bit resolution
Integral linearity
±1.5 LSB typical
Supply voltage (VDD)
1.2 V to 3.6 V · specified performance range; VDD is also the ADC reference (no internal reference)
Quiescent current
165 µA typical / 240 µA maximum · only under the datasheet test conditions (SBAS405A Power-Supply Requirements): VDD = 1.8 V with sensor off, PD[1:0] = 0,0, 12-bit fast mode (clock = 400 kHz), 34.42k eq rate — at an 8.2k eq rate under the same conditions the typical figure is 39.31 µA
Power-down current
0.8 µA maximum · not addressed, SCL = SDA = 1
PENIRQ pull-up resistor
51 kΩ or 90 kΩ typical · register-selectable, at 25°C and VDD = 1.8 V
Order-code packages
TSSOP-16 (PW) and WCSP-12 (YZG) order codes share one die · the two footprints are not interchangeable
Manufacturer packing
IPW tube 90 / IPWR tape and reel 2,000; IYZGT small reel 250 / IYZGR reel 3,000 · packing quantities, not stock or MOQ
Source: TI SBAS405A · Electrical Characteristics tables (incl. continued); Ordering Information + Package Option Addendum · Reviewed 2026-10-30
QUOTE WORKFLOW

Four checks before a commercial offer.

01

Identity

Exact MPN, manufacturer and suffix

02

Supply

Supplier type, quantity and freshness

03

Evidence

Lot, labels, photos and documents

04

Terms

Price, lead time, payment and shipping

RELATED REFERENCES

Explore more Integrated Circuits records

Browse existing catalog records — same series first, then the same category and manufacturer. These are not confirmed replacements; compatibility requires engineering review.

COMMON QUESTIONS

TSC2007 FAQ

What are the key specifications of TSC2007?

From the verified technical profile: Function: 4-wire resistive touch screen controller with 12-bit ADC · I²C interface; ADC resolution: 12 bits maximum · programmable 8-bit or 12-bit mode; no missing codes 11 bits minimum at 12-bit resolution; Integral linearity: ±1.5 LSB typical. These are the catalog-recorded values for TSC2007 — always re-check them against the manufacturer datasheet revision quoted on your BOM before finalizing the design.

What should I check before substituting TSC2007 with another I2C touch screen controller?

Match the full ordering code, not the series name: package (TSSOP-16 / WCSP-12), temperature grade and packing all ride on the suffixes. A same-series code in a different package is a different orderable device, so confirm the substitute against the Texas Instruments datasheet before changing the BOM.