100+ staff · 1,500+ m² in Shenzhen and Hong Kong · Since 2002
ProductsIntegrated CircuitsCH32V307VCT6
PACKAGE REFERENCELQFP-100Confirm case, pinout and ordering suffix before purchase.
MANUFACTURER PART RECORD

CH32V307VCT6

WCH

CH32V307VCT6 is a RISC-V microcontroller from WCH in a 100-pin LQFP package — the high-end of the CH32V line for I/O-heavy embedded control. The 100-pin RISC-V option is the selection point: maximum peripherals and pins on the open RISC-V architecture, for designs that want ARM-class I/O without ARM licensing cost in the BOM. Selection advice: the VCT6 suffix denotes this density and the LQFP-100 package — match the full code. Confirm your toolchain supports the WCH RISC-V core and verify peripheral requirements against the datasheet.

Integrated Circuits32-bit microcontrollerLQFP-100
MPN
CH32V307VCT6
Manufacturer
WCH
Family
32-bit microcontroller
Package
LQFP-100
Manufacturer channel coverage
Checked by RFQ
Data last checked
Commercial check required
Required order checks
Suffix, package, date code, lot, source and traceability
PROCUREMENT DATA

Identity and sourcing requirements.

MANUFACTURER DATA REVIEW

Key technical specifications

Ordering-code highlights reviewed against official manufacturer documentation.

Function
RISC-V microcontroller (QingKe V4F core, IMAFC) with USB, Ethernet MAC and rich peripherals · LQFP-100, 14 mm × 14 mm, 0.5 mm pitch
Device resources (VC variant)
100 pins; 256 KB flash; 64 KB SRAM; 80 GPIO (Table 2-1). Flash/SRAM can be re-partitioned by the user select word (192K+128K / 224K+96K / 256K+64K / 288K+32K per the data-sheet note)
Maximum clock
FHCLK, FPCLK1 and FPCLK2 each 144 MHz maximum (Table 4-2)
Supply voltages
VDD 2.4 V to 3.6 V (3.0 V to 3.6 V when USB or Ethernet is used); VDDA 2.4 V to 3.6 V; VBAT 1.8 V to 3.6 V (Table 4-2)
Run-mode current
IDD 22.4 mA typical with all peripherals enabled / 12.4 mA typical disabled, at FHCLK = 144 MHz from external clock, VDD = 3.3 V, code running from internal flash (Table 4-6)
Low-power currents
Stop mode 30 µA typical (low-power regulator, oscillators off); standby 1.8 µA typical (LSI on, IWDG off, RAM unpowered) (Table 4-8)
Reset thresholds
VPOR/PDR depends on the VLEVEL configuration: 2.2 V rising / 2.2 V falling with VLEVEL = 1 (Table 4-4-1); 1.59 V rising / 1.57 V falling with VLEVEL = 0 (Table 4-4-2); hysteresis 20 mV in both configurations
Internal reference
VREFINT 1.17 V minimum / 1.2 V typical / 1.23 V maximum over −40 °C to 85 °C (Table 4-5)
ADC
fADC 14 MHz maximum; sampling 0.05 MHz to 1 MHz; input range 0 V to VREF+ (Table 4-42); ADC errors at fPCLK2 = 56 MHz, fADC = 14 MHz, RAIN < 10 kΩ, VDDA = 3.3 V: offset error EO ±4 LSB, differential nonlinearity ED ±2 LSB, integral nonlinearity EL ±2.5 LSB (Table 4-44)
Operating temperature
Ambient −40 °C to 85 °C; junction −40 °C to 105 °C (Table 4-2)
Absolute maximum ratings
VDD − VSS −0.3 V to 4.0 V (including VDDA and VDD); VIO − VSS −0.3 V to 4.0 V; 5 V-tolerant (FT) pins VSS − 0.3 V to 5.5 V; USB and 10M Ethernet PHY pins VSS − 0.3 V to VDD + 0.3 V; all other pins VSS − 0.3 V to VIO + 0.3 V; variation between different supply pins or ground pins 50 mV maximum; ESD (HBM) 4 kV, 3 kV on the USB pins PA11/PA12; total current through the VDD, VDDA and VIO power lines 150 mA and through the VSS ground lines 150 mA; per-pin I/O sink/source current 25 mA; injected current ±5 mA per pin and ±25 mA in total; storage −40 °C to 125 °C (Table 4-1)
Order-code construction
VCT6 decodes per the WCH naming rules: V = 100 pins, C = 256 KB flash, T = LQFP, 6 = industrial temperature grade (−40 °C to 85 °C)
Manufacturer packing
Not specified in the V3.9 data sheet (Chapter 5 lists the LQFP-100 package and the order model without a packing form); confirm the carrier at quotation
Source: WCH CH32V303/305/307/317 Data Sheet V3.9 (CH32V307DS0, WCH official Chinese edition) · Table 2-1 device resources, Table 4-1 Absolute Maximum Ratings, Table 4-2 Operating Conditions, Tables 4-4-1/4-4-2 Reset Thresholds, Table 4-5 Internal Reference, Tables 4-6/4-8 Currents, Table 4-42 ADC Characteristics, Table 4-44 ADC Errors, Chapter 5 Package and Ordering · Reviewed 2026-11-02
QUOTE WORKFLOW

Four checks before a commercial offer.

01

Identity

Exact MPN, manufacturer and suffix

02

Supply

Supplier type, quantity and freshness

03

Evidence

Lot, labels, photos and documents

04

Terms

Price, lead time, payment and shipping

RELATED REFERENCES

Explore more Integrated Circuits records

Browse existing catalog records — same series first, then the same category and manufacturer. These are not confirmed replacements; compatibility requires engineering review.

COMMON QUESTIONS

CH32V307VCT6 FAQ

What are the key specifications of CH32V307VCT6?

From the verified technical profile: Function: RISC-V microcontroller (QingKe V4F core, IMAFC) with USB, Ethernet MAC and rich peripherals · LQFP-100, 14 mm × 14 mm, 0.5 mm pitch; Device resources (VC variant): 100 pins; 256 KB flash; 64 KB SRAM; 80 GPIO (Table 2-1). Flash/SRAM can be re-partitioned by the user select word (192K+128K / 224K+96K / 256K+64K / 288K+32K per the data-sheet note); Maximum clock: FHCLK, FPCLK1 and FPCLK2 each 144 MHz maximum (Table 4-2). These are the catalog-recorded values for CH32V307VCT6 — always re-check them against the manufacturer datasheet revision quoted on your BOM before finalizing the design.